HP 6100 HP StorageWorks Fibre Channel Disk Drive Replacement Instructions (569 - Page 1
HP 6100 Manual
View all HP 6100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
HP StorageWorks Fibre Channel disk drive replacement instructions These instructions apply to the EVA3000/5000 and EVA4x00/6x00/8x00 products. The part may also be used in other HP products. See the documentation for your specific product for detailed replacement instructions. About this document This document describes the procedure for replacing the Fibre Channel disk drive used in the EVA products. Warranty information If the product in which this part is being replaced is still under HP warranty, then the replacement part(s) referred to in these Replacement Instructions is provided under the terms and conditions of the Hewlett-Packard Company Limited Warranty for that product. A copy of this Limited Warranty may be viewed at: http://h18006.www1.hp.com/products/storageworks/warranty.html If this is a trade sale part (product out of warranty), then the replacement part(s) referred to in these replacement instructions is provided under HP's express limited warranty statement, which may be viewed at: http://www.hp.com/go/storagewarranty The replacement part takes on either the Limited Warranty Period of the part being replaced or a ninety-day period that begins upon installation of the replacement part, whichever is greater. The only warranty for this replacement product is as noted above. Nothing in these replacement instructions should be construed as constituting an additional warranty. The information provided in these replacement instructions is provided "AS IS" and HP is not liable for technical or editorial errors or omissions contained herein. © Copyright 2005 Hewlett-Packard Development Company, L.P. Sixth edition June 2007 The information in this document is subject to change without notice. Printed in Puerto Rico www.hp.com Before you begin Observe the following precautions when replacing the disk: • Ensure you have a replacement part available before removing the failed component. Removing a component impacts cooling within the enclosure. • Do not remove more than one disk at a time from the enclosure. Doing so will impact cooling of the enclosure and may cause data loss. • Parts can be damaged by electrostatic discharge. Use proper anti-static protection. • Have a copy of the product user guide available for reference. You can download a copy of the user guide from the product support page on the HP website. Disk replacement video To assist you in replacing the disk, a replacement video is available. You can view the video at the following website. The same procedure is used for EVA3000/5000 and EVA4x00/6x00/8x00 products. http://www.thesml.com/csr.htm?prodSeriesId=470490 *5697-6791* Types of disk failures There are two types of disk failures: • Hard failure: The disk is no longer functioning properly and has been assigned a failed status. This type of failure is indicated by an operational state of Failed in HP Command View EVA. The amber fault status indicator on the disk is typically on. • Impending failure: Although the disk is still functioning, errors have been detected that indicate an impending failure. This type of failure is not accompanied by a failed status. Page 1