HP A6795A Installation Guide - Page 5

1 HP-UX Installation This chapter contains HP-UX installation information for the A6795A Fibre Channel Mass Storage Adapter and contains the following sections: • "Supported Configurations" • "Superdome Installation" • "Installation Prerequisites" • "Patches" • "Installing Driver Software" • "Installing the Adapter Online" • "Installing the Adapter Offline" • "Attach Other Devices" • "Verifying Installation" • "Verifying Connectivity" • "Interpreting Hardware Paths" Thank you for purchasing HP I/O Cards If you are installing an HP I/O card as an add-in device, please review this document before attempting installation. If this card was factory installed in your server, you can skip to the Verifying Installation section. HP welcomes your input. Please email us at: [email protected] with comments or suggestions on HP I/O Cards or related documentation. All product documentation, including a comprehensive Support Guide, Installation Guide, Release Notes, and Support Matrix are available online at: http://docs.hp.com 1. Click on browse by topic. 2. Click on networking and communications. 3. Click on the Fibre Channel product category. Supported Configurations Verify compliance with the supported configurations listed in the HP Fibre Channel Host Bus Adapter Support Matrix, available at: http://www.docs.hp.com/hpux/netcom/index.html#Fibre%20Channel Alternately, you can access the HP Fibre Channel Host Bus Adapter Support Matrix, as well as other Fibre Channel documentation as follows: a. go to http://www.docs.hp.com b. select "browse by topic" c. select "Networking and Communications" d. select "Fibre Channel" Chapter 1 5