HP BL20p G3 Dual NC370i ProLiant Essentials Intelligent Networking Pack Linux - Page 9
Stopping Virus Throttle, Restarting Virus Throttle
View all HP BL20p G3 Dual NC370i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
The overall status, statistics, and delay queue information since the Virus Throttle filter driver was initialized is displayed. Status information • Virus-like activity is currently occurring. "Virus-like" activity is currently detected. • Virus-like activity has not occurred. No "virus-like" activity is currently detected and none has been detected since the filter driver was initialized. • Virus-like activity has occurred in the past. No "virus-like" activity is currently detected, but "virus- like" activity has been detected since the filter driver was initialized. Statistics • Connection establishing packets. Number of connection packets seen. • Packets passed without delay. Number of connection packets that were passed without a delay because the target was a known host. • Packets placed on queue. Number of connection packets queued. • Packets removed from queue. Number of connection packets removed from the delay queue. • Currently queued packets. Number of connection packets currently on the delay queue. • Maximum packets on queue. Maximum number of packets on the queue at any point since Virus Throttle was last started. • Times virus-like activity seen. Number of times "virus-like" activity was detected. • Packets dropped due to queue overflow. Number of packets that were dropped due to the delay queue being full. Configuration information • Delay queue size. The maximum number of connection requests in the delay queue. • Delay queue seconds. The rate at which the oldest connection request and all other connection requests to that same host are removed and passed down the protocol stack. • Known host working set size. The number of known hosts. • Delay queue high water mark. The number of connection requests in the delay queue at which point "virus-like" activity is indicated. • Delay queue low water mark. The number of connection requests in the delay queue below which "virus-like" activity is no longer indicated. Stopping Virus Throttle To manually stop Virus Throttle, run the following command. # /etc/init.d/hp-vt stop Restarting Virus Throttle Run the following command to restart Virus Throttle. # /etc/init.d/hp-vt restart Using Virus Throttle 9