HP BL460c Citrix XenServer from HP Getting Started Guide - Page 3
Virtualization, IMPORTANT, Citrix XenServer, Reference Manual
UPC - 884420306849
View all HP BL460c manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
o HP spare kit part number 583306-001 • Flash media (USB flash drive) o HP 4GB USB flash media drive key o HP part number 580385-B21 o HP spare kit part number 583307-001 Citrix XenServer from HP does not support any other USB or SD card devices. 2. Download the installation software from Software Depot home (http://software.hp.com/ ), and then select Virtualization. 3. Burn the installation ISO to a CD-ROM, or move the ISO image to a location accessible using the Virtual Media capabilities of iLO 2. NOTE: The CD-ROM is bootable. Boot the server and choose to install the Citrix XenServer from HP product either to the hard drive or to flash media (USB key or SD card). The flash media must be installed into the internal port on your ProLiant server. 4. Set up the server hardware, and if desired, connect your server to the network. If installing to flash media (USB or SD Card), you must install the flash media into the internal port on your ProLiant server. For specific instructions on how to access the internal flash media (USB or SD card) port, see the server documentation included with your server. NOTE: The server must have access to either locally attached disk storage or a supported shared storage device. For advanced storage configurations, see the documentation for the remote storage devices and the storage chapter in the Citrix XenServer Reference Manual. For hardware information, see the server documentation included with your server. 5. Access the server console in one of the following ways: o Locally-Use your local keyboard and monitor. o Remotely-Use iLO Integrated Remote Console remotely from a network client using a web browser. Remote setup requires HP iLO 2 Advanced Pack, which is sold separately for HP ProLiant ML and DL servers. The remote graphics capability is included with BL servers. IMPORTANT: After you boot up the server, you must press the correct function key when prompted to enter setup mode to configure boot order, configure hardware virtualization, and configure iLO and the Smart Array controller. Familiarize yourself with the following steps and prompts. Each prompt is available for only a few seconds during the boot process.