HP Blackbird 002-21A HP Blackbird Gaming System - Upgrading and Servicing - Page 46
Installing an add-in card
View all HP Blackbird 002-21A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Installing an add-in card 1 If necessary, remove the add-in card slot cover or the existing add-in card. See "Removing an add-in card" on page 39. 2 Locate the card slot on the motherboard inside the chassis. In the following figure, (A) is a PCI-E (Express) x 16 connector, and (B) is a PCI connector. Your computer may vary. A A B A B 3 Inside the chassis, position the add-in card over the add-in card connector. For some add-in cards, tip the end of the card into the exterior slot opening, and then position the card over the add-in card connector. For some long add-in cards, insert the right side of the card into the slot guides toward the right (front) of the chassis. 4 Gently but firmly press the card straight into the add-in card slot so that the whole connector seats properly. 42 Upgrading and Servicing Guide