HP Brocade 8/12c Brocade Fabric OS Command Reference Manual Supporting Fabric - Page 784

22 portLoopbackTest portLoopbackTest SYNOPSIS Performs a functional test of port N->N path. portloopbacktest [--slot slot] [-nframes count] [-lb_mode mode] [-spd_mode mode] [-ports itemlist] ceeportloopbacktest [--slot slot] [-nframes count] [-lb_mode mode] [-spd_mode mode] [-ports itemlist] DESCRIPTION Use this command to verify the functional operation of the switch. The portLoopbackTest and ceePortLoopbackTest commands are platform-specific versions of the same test. The portLoopbackTest command is supported on all Goldeneye2 and Condor-based platforms. Use ceePortLoopbackTest on FCoE platforms only. On all other platforms, use portLoopbackTest. Refer to the Fabric OS Troubleshooting and Diagnostics Guide, Appendix A, for a table that correlates ASIC type with switch models. This test sends frames from a given port's transmitter and loops them back into the same port's receiver. The loopback is done at the parallel loopback path. The path traversed in this test does not include the media or the fiber cable. Only one frame is transmitted and received at any given time. An external cable is not required to run this test. The port LEDs flicker green rapidly while the test is running. The test performs the following operations: 1. Sets all ports for parallel loopback. 2. Creates a frame F of maximum data size (2,112 bytes). 3. Transmits the frame F through port N. 4. Picks up the frame from the same port N. 5. Checks if any of the following eight statistic error counters report nonzero values: ENC_in, CRC_err, TruncFrm, FrmTooLong, BadEOF, Enc_out, BadOrdSet, DiscC3 6. Checks whether the transmit, receive, or class 3 receiver counters are stuck at some value. 7. Checks whether the number of frames transmitted is not equal to the number of frames received. 8. Repeats Steps two through seven for all ports until one of the following conditions is met: a. The number of frames (or pass count) requested is reached. b. All ports are marked bad. At each pass, the frame is created from a different data type of a palette of seven. If seven passes are requested, seven different data types are used in the test. If eight passes are requested, the first seven frames use unique data types, and the eighth is the same as the first. The seven data types are: 750 Fabric OS Command Reference 53-1001764-01