HP Brocade BladeSystem 4/12 HP StorageWorks B-series Data Center Fabric Manage - Page 44

Closed defect summary Solution M-EOS-based switches can be managed only by one DCFM server at a time. If two DCFM servers attempt to manage the same M-EOS fabric, and the fabric is then unmonitored in one of the DCFM servers to allow the other DCFM server can manage the fabric, a too many sessions error message appears, and that server still cannot gain manageability of the M-EOS fabric. Fixed in DCFM 10.3.2 If a CLI supportsave is in progress, an attempt to use DCFM to collect supportsave data to the same switch fails. Fixed in DCFM 10.3.2 DCFM allows you to add a switch with a domain ID greater than 31 in interopmode 2 to the zone, but zone activation fails with a Bad Zone configuration error. Fixed in DCFM 10.3.2 The Add FCIP Tunnel dialog online help is missing information about the Select Switch Two button. Fixed in DCFM 10.3.2 After a host is discovered, Auto enclosure is not created in the Fabric view, and the wrong fabric WWN is shown on the host view. Fixed in DCFM 10.3.2 When activating a zone with report generation enabled for an M-EOSonly fabric, an error message is displayed and a report is not gener- Fixed in DCFM 10.3.2 ated. After a switch name is changed, the Master Log event count increments with the old source name. Fixed in DCFM 10.3.2 After a host name is changed, the DCFM client does not reflect the new name until the client is relaunched. Fixed in DCFM 10.3.2 After adding a single side tunnel to a DC SAN or 4/256 Director with Multiprotocol Router Blade, the VE_Port number does not display with the Tunnel ID. nl After adding a second side tunnel, the FCIP Tunnel/Circuit Configuration Report returns an error. Fixed in DCFM 10.3.2 The HTML image on the DVD displays Professional Edition and must be replaced with the latest image. Fixed in DCFM 10.3.2 When the TI zone is modified, the Zoning dialog displays an Alert message before activating, and the change does not take place in the Fixed in DCFM 10.3.2 zone configuration. After creating a third circuit, the horizontal scroll bar does not appear in the FCIP Tunnel dialog, Circuit tab. Fixed in DCFM 10.3.2 nl Workaround prior to this version: nl Close and reopen the FCIP Tunnel dialog. 44