HP CC470A HP Color LaserJet CP3525 Series Printers - User Guide - Page 196
Usb Storage <x> Is Not Functional, Waiting For Tray <x> To Lift
View all HP CC470A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 196 highlights
Table 11-1 Control-panel messages (continued) Control panel message Description Recommended action UNSUPPORTED DRIVE INSTALLED A non-supported hard drive has been installed. Turn off the product, remove the hard drive, and then turn on the product. USB ACCESSORY ERROR This message appears when a connected USB accessory draws too much power. When this happens, the ACC port is disabled and printing stops. Printing can continue. The USB device should be removed. USB storage initializing One of the parameters of the USB storage No action is necessary. device is initializing. USB STORAGE IS NOT FUNCTIONAL A parameter in the USB storage is not working correctly. 1. Turn product off. 2. Disconnect the USB storage accessory, and replace with a new USB storage accessory. USB STORAGE IS REMOVED A USB storage accessory has been disconnected. 1. Turn product off. 2. Reconnect the USB storage accessory. 3. Turn product on. USB STORAGE DEVICE FAILURE The specified device has failed. Press the OK button to clear. To clear press OK USB STORAGE FILE OPERATION FAILED A PJL file system command attempted to perform an illogical operation. To clear press OK Press the OK button to clear. USB STORAGE FILE SYSTEM IS FULL To clear press OK A PJL file system command could not store Press the OK button to clear. something on the file system because the file system was full. USB STORAGE IS WRITE PROTECTED To clear press OK The file system device is protected and no new files can be written to it. Press the OK button to clear. USB STORAGE NOT INITIALIZED This file-storage component must be initialized before use. Use the embedded Web server or HP Web Jetadmin to initialize the component. WAIT FOR PRINTER TO REINITIALIZE This message can appear for a variety of reasons: The RAM DISK settings changed before the product has rebooted. The product is restarting after changing external device modes. The user has exited Diagnostics. A new formatter has been installed with an old engine or a new engine has been installed with an old formatter. No action is necessary. WAITING FOR TRAY TO LIFT The specified tray is lifting paper for feeding. No action is necessary. WARMING UP The product is coming out of Sleep mode. No action is necessary. WRONG CARTRIDGE IN SLOT The indicated slot for a print cartridge contains a cartridge that is not the correct color. From left to right, the print cartridges should be installed in this order: ● Yellow ● Magenta Remove the print cartridge from that slot, and install a cartridge that is the correct color. 184 Chapter 11 Solve problems ENWW