HP CM6030f User Guide - Page 287
Print-quality-troubleshooting s, Waste Bin = Normal/Alternate
UPC - 883585781232
View all HP CM6030f manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 287 highlights
performed after each job that is printed from Tray 1. Using Alternate mode increase wear on all the print cartridges. ● Tracking Control: This setting should always be set to On. ● Cleaning Frequency = Normal/Alternate: Set this feature to Alternate if you are seeing defects in the printed output that repeat at 38 mm (1.5 inch) intervals. This feature increases the frequency at which the C roller is cleaned. Setting this feature to Alternate might also reduce printing speed and increase the frequency of consumable replacement. ● D-Blade Bias = Normal/Alternate: Set this feature to Alternate if you are seeing short, white, vertical lines in the printed output. The Alternate setting might also cause dark spots in the printed output, so be sure to test this setting on a few print jobs. ● Waste Bin = Normal/Alternate: Try setting this feature to Alternate if you are seeing lengthwise toner streaks in your printed output, especially in jobs with low toner coverage. ● Discharge Brush = Off/On: Enable this feature in low temperature and low humidity environments if you are seeing specks of toner scattered on double-sided jobs using lightweight paper and longer than ten pages. Print-quality-troubleshooting pages Use the built-in print-quality-troubleshooting pages to help diagnose and solve print-quality problems. 1. Scroll to and touch Administration 2. Scroll to and touch Troubleshooting. 3. Touch PQ Troubleshooting. 4. Touch Print. The product returns to the Ready state after printing the print-quality-troubleshooting pages. Follow the instructions on the pages that print out. ENWW Correct print quality and copy quality problems 271