HP Cisco Catalyst Blade Switch 3020 Release Notes for Cisco Catalyst Blade Swi - Page 14
Resolved Caveats
View all HP Cisco Catalyst Blade Switch 3020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Resolved Caveats • CSCtl32991 Unicast EIGRP packets destined for the switch are sent to the host queue instead of to the higher priority routing protocol queue. Note This does not occur when packets are routed through the switch to another destination. There is no workaround. • CSCtl60247 When a switch running Multiple Spanning Tree (MST) is connected to a switch running Rapid Spanning Tree Protocol (RSTP), the MST switch acts as the root bridge and runs per-VLAN spanning tree (PVST) simulation mode on boundary ports connected to the RST switch. If the allowed VLAN on all trunk ports connecting these switches is changed to a VLAN other than VLAN 1 and the root port of the RSTP switch is shut down and then enabled, the boundary ports connected to the root port move immediately to the forward state without going through the PVST+ slow transition. There is no workaround. • CSCtl81217 When a switch is using a DHCP server to assign IP addresses and an interface on the switch has RIP enabled, if the switch reloads, the interface loses some RIP configuration (specifically RIP authentication mode and RIP authentication key-chain). This does not happen when the IP address is statically configured on the interface. The problem occurs only when you configure RIP before an IP address is assigned by the DHCP server. There is no workaround, but you can use an embedded event manager (EEM) script to add the interface configuration commands on the interface: ip rip authentication mode ip rip key-chain • CSCtq01926 When you configure a port to be in a dynamic VLAN by entering the switchport access vlan dynamic interface configuration command on it, the switch might reload when it processes ARP requests on the port. The workaround is to configure static VLANs for these ports. Resolved Caveats • CSCtg00542 A Link Aggregation Control Protocol (LACP) bundle takes up to 70 seconds to form when NetFlow sampling is enabled. The workaround is to disable NetFlow sampling. • CSCtg11547 When you configure a switch to send messages to a syslog server in a VPN Routing and Forwarding (VRF) instance, the messages are not sent to the server. The workaround is to remove the VRF configuration. Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(58)SE and Later 14 OL-24325-01