HP Cisco Catalyst Blade Switch 3020 Release Notes for Cisco Catalyst Blade Swi - Page 15

Resolved Caveats • CSCtg71149 When ports in an EtherChannel are linking up, the message EC-5-CANNOT_BUNDLE2 might appear. This condition is often self-correcting, indicated by the appearance of EC-5-COMPATIBLE message following the first message. On occasion, the issue does not self-correct, and the ports may remain unbundled. The workaround is to reload the switch or to restore the EtherChannel bundle by shutting down and then enabling the member ports and the EtherChannel in this order: - Enter the shutdown interface configuration command on each member port. - Enter the shutdown command on the port-channel interface. - Enter the no shutdown command on each member port. - Enter the no shutdown command on the port-channel interface. • CSCth44403 When you connect a switch as a VLAN Trunk Protocol (VTP) client to a Catalyst 4000 switch configured as a VTP client or server and the VTP database contains more than 512 VLANs, the database is not correctly updated. The workaround is to connect the VTP client directly to a Catalyst 6500 VTP server. • CSCti27620 The switch does not generate SNMP traps when a power supply is disconnected. There is no workaround. • CSCti37197 Enabling the Cisco Discovery Protocol (CDP) on a tunnel interface causes the switch to fail when a a CDP packet is received on the interface. Note Tunnels are not supported on these platforms. The workaround is to use the no cdp enable interface configuration command to disable CDP on the interface. • CSCti61145 When you configure storm control with range command on two interfaces that belong to an EtherChannel group, this message appears: %SYS-3-CPUHOG: Task is running for (2097)msecs, more than (2000)msecs (0/0), process = Virtual Exec. The workaround is to configure storm control on a port channel interface. • CSCti69845 When MAC Authentication Bypass (MAB) is used in multi-authentication mode, a security violation occurs after successful authentication. The workaround is to use a different authentication mode (single, multidomain or multihost). • CSCti78365 The config.text.backup file is present after the switch is restored to the factory defaults. There is no workaround. OL-24325-01 Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(58)SE and Later 15