HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP So - Page 234

Configuring Smartports Macros Chapter 9 Configuring Smartports Macros Follow these guidelines when you apply a Cisco-default Smartports macro on an interface: • Display all macros on the switch by using the show parser macro user EXEC command. Display the contents of a specific macro by using the show parser macro macro-name user EXEC command. • Keywords that begin with $ mean that a unique parameter value is required. Append the Cisco-default macro with the required values by using the parameter value keywords. The Cisco-default macros use the $ character to help identify required keywords. There is no restriction on using the $ character to define keywords when you create a macro. Creating Smartports Macros Beginning in privileged EXEC mode, follow these steps to create a Smartports macro: Step 1 Step 2 Step 3 Step 4 Command configure terminal macro name macro-name end show parser macro name macro-name Purpose Enter global configuration mode. Create a macro definition, and enter a macro name. A macro definition can contain up to 3000 characters. Enter the macro commands with one command per line. Use the @ character to end the macro. Use the # character at the beginning of a line to enter comment text within the macro. (Optional) You can define keywords within a macro by using a help string to specify the keywords. Enter # macro keywords word to define the keywords that are available for use with the macro. Separated by a space, you can enter up to three help string keywords in a macro. Macro names are case sensitive. For example, the commands macro name Sample-Macro and macro name sample-macro will result in two separate macros. We recommend that you do not use the exit or end commands or change the command mode by using interface interface-id in a macro. This could cause any commands following exit, end, or interface interface-id to execute in a different command mode. For best results, all commands in a macro should be in the same configuration mode. Return to privileged EXEC mode. Verify that the macro was created. The no form of the macro name global configuration command only deletes the macro definition. It does not affect the configuration of those interfaces on which the macro is already applied. This example shows how to create a macro that defines the switchport access VLAN and the number of secure MAC addresses and also includes two help string keywords by using # macro keywords: Switch(config)# macro name test switchport access vlan $VLANID switchport port-security maximum $MAX #macro keywords $VLANID $MAX @ Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide 9-4 OL-8915-01