HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP So - Page 513

Chapter 26 Configuring Network Security with ACLs Configuring VLAN Maps Creating a VLAN Map Each VLAN map consists of an ordered series of entries. Beginning in privileged EXEC mode, follow these steps to create, add to, or delete a VLAN map entry: Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 Command configure terminal vlan access-map name [number] action {drop | forward} match {ip | mac} address {name | number} [name | number] end show running-config copy running-config startup-config Purpose Enter global configuration mode. Create a VLAN map, and give it a name and (optionally) a number. The number is the sequence number of the entry within the map. When you create VLAN maps with the same name, numbers are assigned sequentially in increments of 10. When modifying or deleting maps, you can enter the number of the map entry that you want to modify or delete. Entering this command changes to access-map configuration mode. (Optional) Set the action for the map entry. The default is to forward. Match the packet (using either the IP or MAC address) against one or more standard or extended access lists. Note that packets are only matched against access lists of the correct protocol type. IP packets are matched against standard or extended IP access lists. Non-IP packets are only matched against named MAC extended access lists. Return to global configuration mode. Display the access list configuration. (Optional) Save your entries in the configuration file. Use the no vlan access-map name global configuration command to delete a map. Use the no vlan access-map name number global configuration command to delete a single sequence entry from within the map. Use the no action access-map configuration command to enforce the default action, which is to forward. VLAN maps do not use the specific permit or deny keywords. To deny a packet by using VLAN maps, create an ACL that would match the packet, and set the action to drop. A permit in the ACL counts as a match. A deny in the ACL means no match. Examples of ACLs and VLAN Maps These examples show how to create ACLs and VLAN maps that for specific purposes. Example 1 This example shows how to create an ACL and a VLAN map to deny a packet. In the first map, any packets that match the ip1 ACL (TCP packets) would be dropped. You first create the ip1ACL to permit any TCP packet and no other packets. Because there is a match clause for IP packets in the VLAN map, the default action is to drop any IP packet that does not match any of the match clauses. Switch(config)# ip access-list extended ip1 Switch(config-ext-nacl)# permit tcp any any Switch(config-ext-nacl)# exit Switch(config)# vlan access-map map_1 10 Switch(config-access-map)# match ip address ip1 Switch(config-access-map)# action drop OL-8915-01 Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide 26-25