HP Cisco MDS 8/24c Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Rel - Page 34

Caveats Send documentation comments to [email protected] The following error can be seen in the error-history file for the acltcam process: switch# att mod x switch# show process acltcam internal errors ... 128) Event:E_DEBUG, length:91, at 553029 usecs after Fri Jan 21 20:41:27 2011 [107] acl_tcam_local_domain_list_init (3331):Unable to get local domains for existing vsans ... Workaround: This issue is resolved. • CSCtn01631 Symptom: The Call Home process crashes and restarts when many RMON hc alerts are sent to Call Home. Workaround: This issue is resolved. • CSCtn88331 Symptom: When you configure an FL port at any speed on a Generation 3 module, the speed is set by default to 2 Gbps. For example, if you configure the speed to be 8 Gbps, the actual speed on the hardware is set to 2 Gbps. This issue only occurs when an FL device is attached to a Generation 3 module. Workaround: This issue is resolved. • CSCtq60165 Symptom: The IPS module fails and then reloads when FTA is enabled on the FCIP link for the Read Acceleration feature. This issue occurs when the software is in recovery mode and there appear to be packet drops on the FICON interfaces. Workaround: This issue is resolved. • CSCtd04154 Symptom: The DMM CPP interface cpp1/1/1 does not come up unless there is an active port in VSAN 1, which is the DMM Management VSAN. There is no interface defined or up in VSAN 1. Workaround: This issue is resolved. • CSCte70856 Symptom: The Cisco Call Home feature stops sending Call Home alerts. In some situations, the Call Home feature might not be able to be configured or displayed. In addition, it might not be possible to save the configuration. The following syslog messages are logged: %KERN-2-SYSTEM_MSG: mts_print_longest_queue_state: opcode counts for first and last 50 messages in pers_q of sap 66: - kernela %KERN-2-SYSTEM_MSG: mts_print_msg_opcode_in_queue: opcode 4853 - 100 messages kernel %KERN-2-SYSTEM_MSG: mts_acquire_q_space() failing - no space in dst sap 66, uuid 63, src sap 28, opcode 4853 - kernel This issue might be seen when the message level configured in Call Home is higher than that of the incoming alerts, such as from the RMON alerts from the port monitor feature. Workaround: This issue is resolved. • CSCtl53991 Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 5.2(1) 34 OL-25090-01