HP Cisco MDS 9124 Cisco MDS 9100 Series Hardware Installation Guide (OL-17951- - Page 41
Installing Front Rack-Mount Brackets for Cabinets with 26 Inches or Greater of Rail Spacings
View all HP Cisco MDS 9124 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Chapter 2 Installing the Cisco MDS 9100 Series Installing the Switch in a Cabinet with Insufficient Front Clearance Send documentation comments to [email protected] Installing Front Rack-Mount Brackets for Cabinets with 26 Inches or Greater of Rail Spacings The front rack-mount brackets for the Cisco MDS 9100 Series switch must be installed onto the switch prior to installing the switch into the cabinet. Follow these steps for cabinets with front-mounting rail to rear-mounting rail spacings greater or equal to 26 inches. Step 1 Step 2 Install the front rack-mount brackets as follows: a. Position one of the front rack-mount brackets against the side of the switch and align the screw holes as shown in Figure 2-8. Then attach the bracket to the switch with the three M4 screws originally provided with the bracket. b. Repeat with the other front-rack mount bracket on the other side of the switch. Install the C brackets as follows: Note Two C brackets are shipped preinstalled on the switch, using three M3 screws per bracket. This installation step is only necessary if the C brackets were removed. a. Position one of the C brackets against the side of the switch and align the screw holes as shown in Figure 2-8. Then attach the bracket to the switch with the three M3 screws originally provided with the bracket. b. Repeat with the other C bracket on the other side of the switch. Figure 2-8 Front Rack-Mount Brackets and C Brackets Installed on the Cisco MDS 9100 Series 96616 2 1 Front rack-mount bracket 1 2 C bracket OL-17951-02 Cisco MDS 9100 Series Hardware Installation Guide 2-13