HP Cisco MDS 9124 Cisco MDS 9100 Series Hardware Installation Guide (OL-17951- - Page 74
Requirements Specific to Perforated Cabinets, Reference Perforated Cabinet
View all HP Cisco MDS 9124 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Cabinet and Rack Requirements Appendix A Cabinet and Rack Installation Send documentation comments to [email protected] • For four-post EIA cabinets (perforated or solid-walled): - The minimum spacing for bend radius for fiber-optic cables should have the front mounting rails of the cabinet offset from the front door by a minimum of 3 in. (7.6 cm), and a minimum of 5 in. (12.7 cm) if cable management brackets are installed on the front of the chassis. - The distance between the outside face of the front mounting rail and the outside face of the back mounting rail should be 23.5 to 34.0 in. (59.7 to 86.4 cm) to allow for rear bracket installation. - There should be a minimum of 2.5 in. (6.4 cm) of clear space between the side edge of the chassis and the side wall of the cabinet. No sizeable flow obstructions should be immediately in the way of the chassis air intake or exhaust vents. Note Optional jumper power cords are available for use in a cabinet. See the "Jumper Power Cord" section on page C-5. Requirements Specific to Perforated Cabinets In addition to the requirements listed in the "General Requirements for Cabinets and Racks" section on page A-1, perforated cabinets must meet the following requirements: • The front and rear doors must have at least a 60 percent open area perforation pattern, with at least 15 sq. in. of open area per rack unit of door height. • We recommend that the roof be perforated with at least 20 percent open area, unless the cabinet only contains Cisco MDS 9100 Series switches, in which case the roof does not have to be perforated. • We recommend an open or perforated cabinet floor to enhance cooling but it is not required. Reference Perforated Cabinet A perforated cabinet that conforms to the above requirements is available from Rittal Corporation: Rittal Corporation One Rittal Place Springfield, OH 45504 Phone: (800) 477-4000 Cabinet P/N: Rittal 9969427 Cabinet description: PS-DK/OEM Cabinet Assembly, 1998 x 600 x 1000 (H x W x D) (42U) Cisco MDS 9100 Series Hardware Installation Guide A-2 OL-17951-02