HP Cisco MDS 9216i Cisco Nexus 5000 Series Hardware Installation Guide (OL-159 - Page 77
Maintaining SFP+ Transceivers and Cables, Connecting to a Fibre Channel Port
View all HP Cisco MDS 9216i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Chapter 3 Connecting the Cisco Nexus 5000 Switch Connecting to a Fibre Channel Port Send documentation comments to [email protected] Step 4 Insert a dust plug onto the end of the cable. Maintaining SFP+ Transceivers and Cables SFP+ transceivers must be kept clean and dust-free to maintain high signal accuracy and prevent damage to the connectors. Attenuation (loss of light) is increased by contamination and should be below 0.35 dB. Consider the following maintenance guidelines: • SFP+ transceivers are static sensitive. To prevent ESD damage, wear an ESD-preventive wrist strap that is connected to the chassis. • Do not remove and insert a transceiver more often than is necessary. Repeated removals and insertions can shorten its useful life. • Keep all optical connections covered when not in use. If they become dusty, clean before using to prevent dust from scratching the fiber-optic cable ends. • Do not touch ends of connectors to prevent fingerprints and other contamination. • Clean regularly; the required frequency of cleaning depends upon the environment. In addition, clean connectors if they are exposed to dust or accidentally touched. Both wet and dry cleaning techniques can be effective; refer to your site's fiber-optic connection cleaning procedure. • Inspect routinely for dust and damage. If damage is suspected, clean and then inspect fiber ends under a microscope to determine if damage has occurred. Connecting to a Fibre Channel Port Use an SFP transceiver to connect to an Fibre Channel port. Removing and Installing SFP Transceivers Caution Excessively removing and installing an SFP transceiver can shorten its life. Do not remove and insert SFP transceivers more often unless it is absolutely necessary. Cisco recommends disconnecting cables before installing or removing SFP transceivers to prevent damage to the cable or transceiver. This section describes the proper method for installing and removing an SFP transceiver. Installing an SFP Transceiver To install an SFP transceiver, follow these steps: Step 1 Attach an ESD-preventive wrist strap and follow its instructions for use. OL-15902-01 Cisco Nexus 5000 Series Hardware Installation Guide 3-7