HP Cluster Platform Hardware Kits v2010 24 Node Cable Management Kit Installat - Page 9
Attaching the Bottom Retainer Bracket, Middle Bracket
View all HP Cluster Platform Hardware Kits v2010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Figure 2-2 Attaching the Bottom Retainer Bracket 3 1 2 1 2 5. After running the cables for the interconnect in the bottom bracket, install the middle retainer spacer bracket with two M6 screws and two M6 cage nuts, but do not tighten completely to allow enough space to accept the top retainer bracket (see Figure 2-3). Figure 2-3 Middle Bracket 3 1 1 2 2 6. Run the interconnect cables through the channels of the upper part of the middle retainer bracket (spacer) to provide strain relief for the interconnect cables (see example of retained cables in the upper part of the assembly in Figure 2-4). 7. Install the top retainer bracket as shown in Figure 2-4 using the space reserved from the loosened screws used in step 5 and Figure 2-3. 8. Torque all four cable management bracket mounting screws to the specified torque shown in Table 1-1. Figure 2-4 shows the completed assembly. 2.1 Installing the Kit 9