HP Dc7100 Troubleshooting Guide - Page 48
Power LED flashes Red ten, Once bad card is identified
UPC - 829160356877
View all HP Dc7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Troubleshooting Without Diagnostics Solving Hardware Installation Problems (Continued) Problem Cause Solution Power LED flashes Red ten times, once every second, followed by a two second pause, and the computer beeps ten times. Bad option card. 1. Check each option card by removing the cards one at time (if multiple cards), then power on the system to see if fault goes away. 2. Once bad card is identified, remove and replace bad option card. 3. Replace the system board. 2-32 www.hp.com Troubleshooting Guide
2–32
www.hp.com
Troubleshooting Guide
Troubleshooting Without Diagnostics
Power LED flashes Red ten
times, once every second,
followed by a two second
pause, and the computer
beeps ten times.
Bad option card.
1. Check each option card by
removing the cards one at time
(if multiple cards), then power
on the system to see if fault goes
away.
2. Once bad card is identified,
remove and replace bad option
card.
3. Replace the system board.
Solving Hardware Installation Problems
(Continued)
Problem
Cause
Solution