HP Designjet 2500/3500cp HP DesignJet 2000/2500 - User's Guide - Page 248
Solving Media-Handling Problems
View all HP Designjet 2500/3500cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 248 highlights
Troubleshooting Solving Media-Handling Problems Solving Media-Handling Problems Roll media Sheet media The Front Panel Keeps Indicating that Media Is Misaligned or Incorrectly Positioned n The roll may be loaded the wrong way. The media should load over the roll toward you. n The media may be loaded at an angle. The right-hand edge must be parallel to the perforated line on the printer. n The media may be loaded at the wrong side of the entry slot. It must be loaded with the right-hand edge against the perforated line on the printer. n The media at an angle. The right-hand edge must be parallel to the perforated line on the printer. n Pushed or held the media may have been pushed or held back as it is loading. You must hold the media only by the edges and immediately release it when the printer is loading. n The media may be crumpled or warped or may have irregular edges. n If you are using hand-cut media, the edges may not form a right-angle or they may be rough. Do not use hand-cut media. Use only purchased sheet media. n If you cannot make the media's leading edge straight, turn on the skew tolerance feature (Device setup / Skew tolerance). See page 3-43, Adjusting Skew Tolerance. NOTE:This feature can skew your print on the page. Prints Do Not Feed Out Properly From the Printer n Make sure the roll cover is completely closed before you print. 11-28