HP Deskpro ap230 Desktop Management Guide - Deskpro Workstation AP230 - Page 19

Master Boot Record Hard Drive has changed., Disable the MBR Security feature.

Get HP Deskpro ap230 PDF manuals and user guides View all HP Deskpro ap230 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

Each time the computer is turned on or restarted, the BIOS compares the MBR of the current bootable disk to the previously-saved MBR. If changes are detected and if the current bootable disk is the same disk from whch the MBR was previously saved, the following message is displayed: 1999 - Master Boot Record has changed. Press any key to enter Setup to configure MBR Security Upon entering Computer Setup, you must  Save the MBR of the current bootable disk;  Restore the previously-saved MBR; or,  Disable the MBR Security feature. You must know the setup password, if one exists. If changes are detected and if the current bootable disk is not the same disk from which the MBR was previously saved, the following message is displayed: 2000 - Master Boot Record Hard Drive has changed. Press any key to enter Setup to configure MBR Security Upon entering Computer Setup, you must  Save the MBR of the current bootable disk; or,  Disable the MBR Security feature. You must know the setup password, if one exists. In the unlikely event that the previously-saved MBR has been corrupted, the following message is displayed: 1998 - Master Boot Record has been lost. Press any key to enter Setup to configure MBR Security Upon entering Computer Setup, you must  Save the MBR of the current bootable disk; or,  Disable the MBR Security feature. You must know the setup password, if one exists. Desktop Management Guide 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
Desktop Management Guide
15
Compaq Confidential - Need to Know Required
Each time the computer is turned on or restarted, the BIOS compares
the MBR of the current bootable disk to the previously-saved MBR. If
changes are detected and if the current bootable disk is the same disk
from whch the MBR was previously saved, the following message is
displayed:
1999 - Master Boot Record has changed.
Press any key to enter Setup to configure MBR Security
Upon entering Computer Setup, you must
Save the MBR of the current bootable disk;
Restore the previously-saved MBR; or,
Disable the MBR Security feature.
You must know the setup password, if one exists.
If changes are detected and if the current bootable disk is
not
the same
disk from which the MBR was previously saved, the following message
is displayed:
2000 - Master Boot Record Hard Drive has changed.
Press any key to enter Setup to configure MBR Security
Upon entering Computer Setup, you must
Save the MBR of the current bootable disk; or,
Disable the MBR Security feature.
You must know the setup password, if one exists.
In the unlikely event that the previously-saved MBR has been
corrupted, the following message is displayed:
1998 - Master Boot Record has been lost.
Press any key to enter Setup to configure MBR Security
Upon entering Computer Setup, you must
Save the MBR of the current bootable disk; or,
Disable the MBR Security feature.
You must know the setup password, if one exists.