HP ENVY 15-j185nr HP ENVY 15 Notebook PC and HP ENVY TouchSmart 15 Notebook PC - Page 88
Connector board, from the system board.
View all HP ENVY 15-j185nr manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Connector board Description For use only on computer models equipped with an AMD processor For use only on computer models equipped with an Intel processor and a graphics subsystem with discrete memory For use only on computer models equipped with an Intel processor and a graphics subsystem with UMA memory Spare part number 720579-001 723372-001 720554-001 Before removing the connector board, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the battery (see Battery on page 41), and then remove the following components: a. Service door (see Service door on page 42) b. mSATA SSD (see mSATA SSD on page 43) c. Hard drive (see Hard drive on page 46) d. Base enclosure (see Base enclosure on page 53) Remove the connector board: 1. Disconnect the connector board cable (1) from the system board. 2. Release the connector board cable from the routing clips (2) built into the top cover and routing channel (3) between the subwoofer and left front speaker. 3. Release the ZIF connector (4) to which the connector board ribbon cable is attached, and then disconnect the connector board ribbon cable from the system board. 78 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts