HP ENVY 15-q000 ENVY m6 Notebook PC ENVY Notebook PC Maintenance and Service G - Page 65
Processor see, Disconnect the following cables from the system board
View all HP ENVY 15-q000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Description For use only on computer models equipped with a separate processor, a graphics subsystem with UMA memory, and the Windows 8 Standard operating system For use only on computer models equipped with a separate processor, a graphics subsystem with UMA memory, and a non-Windows 8 operating system Spare part number 760289-501 760289-001 Before removing the system board, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the battery (see Battery on page 34), and then remove the following components: a. Service cover (see WLAN module on page 35) b. Hard drive (see Hard drive on page 38) c. Base enclosure (see Base enclosure on page 45) d. Display assembly (see Display assembly on page 47) e. Fan (see Fan on page 55) NOTE: When replacing the system board, be sure that the following components are removed from the defective system board and installed on the replacement system board: ● Memory module (see Memory module on page 40) ● Heat sink (see Heat sink on page 60) ● Processor (see Processor on page 62) Remove the system board: 1. Disconnect the following cables from the system board: (1) Connector board cable (2) Connector board ribbon cable (3) Power connector cable (4) Display panel cable (5) Webcam/microphone module cable (6) Wireless antenna cables Component replacement procedures 57