HP EVA P6000 HP Controller Enclosure Midplane Replacement Instructions (593095 - Page 3
HP EVA P6000 Manual
![]() |
View all HP EVA P6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
6. Remove the two power supply modules. a. Move the mounting latch to the left (1, Figure 4), grasp the handle, and pull the power supply out slightly. b. Position one hand under the power supply, and with the other hand, pull the power supply out of the enclosure (2, Figure 4). 8. Remove the management module. a. Lift the latch up on the module (1, Figure 6) and pull the module out slightly. b. Position one hand under the module, and with the other hand, pull the module out of the controller enclosure (2, Figure 6). Figure 4 Removing a power supply . 7. Remove the two controllers. a. Move the mounting latch to the right (1, Figure 5). The controller will slightly eject from the enclosure. b. Position one hand under the controller, and with the other hand, pull the controller out of the enclosure (2, Figure 5). Figure 6 Removing a management module . 9. Remove the top access cover. a. Loosen the cover thumbscrew (1, Figure 7). b. Slide the access panel out and off (2, Figure 7). Figure 5 Removing a controller . Figure 7 Removing top access cover . Page 3
![](/manual_guide/products/hewlettpackard-p6000-hp-controller-enclosure-midplane-replacement-instructions-593095001-2011-a427271/3.png)