HP EVA P6550 HP Controller Enclosure Battery Replacement Instructions (5697-13 - Page 3

4. Position one hand under the battery module, and with the other hand, pull the battery out of the enclosure. Figure 3 Removing a battery module Installing a battery module 1. Insert the battery module into the enclosure. 2. Push the battery module into the enclosure until a click is detected when fully seated. 3. Attach the bezel. Verifying proper operation After replacing the battery module, check the following to verify the component is operating properly: NOTE: Wait approximately three minutes for the system to check the component status. • Verify the green LED is lit or blinking. If not, try reseating the battery module. Press the front bezel onto the controller enclosure. • From HP P6000 Command View, navigate to the component as described in the Verifying component failure section, and check the status. It should be (Good). • Verify that you have the desired LUN presentation to the controllers. Documentation feedback HP is committed to providing documentation that meets your needs. To help us improve the documentation, send any errors, suggestions, or comments to Documentation Feedback ([email protected]). Include the document title and part number, version number, or the URL when submitting your feedback. Page 3