HP Indigo WS6000 Rewinder Service - Page 14

Preparation for replacing an idler, Removing the splicing table

Get HP Indigo WS6000 PDF manuals and user guides View all HP Indigo WS6000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

3. Remove the two screws from both sides of the cylinder and remove the cylinder. 4. Install the new glass cylinder using the original two screws. 5. Connect the air supply tube to the cylinder. 6. Turn the press on. Preparation for replacing an idler Preparation to replace an idler. Removing the splicing table Removal of the splicing table. If you need to remove the splicing table in order to gain access to the idlers for alignment, continue with this procedure. If you do not need to remove the splicing table, proceed to To remove the splicing table: 1. Shut down the press as described in the "Introduction on page 3". 2. Remove the web from the rewinder. 3. Disconnect the input and output air hoses to the air clamps under the table at the point shown below. 4. Cut any tie wraps securing the air tubes from the rewinder wall. Preparation for replacing an idler 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
3.
Remove the two screws from both sides of the cylinder and remove the cylinder.
4.
Install the new glass cylinder using the original two screws.
5.
Connect the air supply tube to the cylinder.
6.
Turn the press on.
Preparation for replacing an idler
Preparation to replace an idler.
Removing the splicing table
Removal of the splicing table.
If you need to remove the splicing table in order to gain access to the idlers for alignment, continue with this
procedure. If you do not need to remove the splicing table, proceed to
To remove the splicing table:
1.
Shut down the press as described in the "
Introduction
on page
3
".
2.
Remove the web from the rewinder.
3.
Disconnect the input and output air hoses to the air clamps under the table at the point shown below.
4.
Cut any tie wraps securing the air tubes from the rewinder wall.
Preparation for replacing an idler
11