HP Integrity Superdome 2 8/16 HP Smart Update Manager 5.1 Release Notes - Page 7

Enable the network ports that HP SUM uses. For more information, see the Enabling ports section in the HP Smart Update Manager User Guide. Minimum requirements for Red Hat Enterprise Linux 6 servers • Ensure that each NIC has an IP address assigned. To get the IP address assigned to a NIC, enter the dhclient command in the console, which launches the NIC interfaces and retrieves an IP address. If a NIC does not have an IP address, HP SUM appears to hang on start up. • RHEL6 console mode NOTE: No X console in either x86 or x86_64 servers. To run HP SUM in silent mode, you must install the base server with defaults and the following RPMs. ◦ Load the hp-snmp-agents rpm and rpms based on hp snmp agent: - lm_sensors-libs-3.1.1-10.el6..rpm - net-snmp-libs-5.5-27.el6..rpm - net-snmp-5.5.27.el6..rpm ◦ To build Linux drivers from source: - kernel-headers-2.6.32-71.el6..rpm - redhat-rpm-config-9.0.3-25.el6.noarch.rpm - kernel-devel-2.6.32-71.el6..rpm - rpm-build-4.8.0-12.el6..rpm - gcc-4.4.4-13.el6..rpm • RHEL6 graphical mode NOTE: The following RPMs must be the 32-bit version even under x86_64 architecture as Linux distributions as HP SUM and several of the RPMs require 32-bit libraries installed. ◦ RHEL6 console mode RMPs ◦ libuuid-2.17.2-6.el6.i686.rpm ◦ freetype-2.3.11-5.el6.i686.rpm ◦ libSM-1.1.0-7.1.el6.i686.rpm ◦ libICE-1.0.6-1.el6.i686.rpm ◦ libXi-1.3-3.el6.i686.rpm ◦ libX11-1.3-2.el6.i686.rpm ◦ libXext-1.1-3.el6.i686.rpm ◦ libxcb-1.5-1.el6.i686.rpm ◦ libXau-1.0.5-1.el6.i686.rpm ◦ libXrender-0.9.5-1.el6.i686.rpm ◦ libXrandr-1.3.0-4.el6.i686.rpm ◦ libXfixes-4.0.4-1.el6.i686.rpm ◦ libXcursor-1.1.10-2.el6.i686.rpm Prerequisites 7