HP Integrity rx2800 Kernel Debugging Guide - Page 23
rx5670 server, rx4640 debugging port
View all HP Integrity rx2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Figure 1-7 rx4640 debugging port To enable the debug port, you must open the server's I/O bay and short a jumper header as follows (jumper not provided): 1. Power the system off and verify that it is disconnected from the main AC power supply. 2. Locate the set of three jumpers directly above the brown edge connector socket (the one resembling an AGP slot) on the motherboard, as shown in the following image. Figure 1-8 Location of three jumpers on rx4640 motherboard 3. Short the middle jumper header, which is the one labeled "console mux." 4. Power the server on. You can now use the "remote" DB9 port as a debugging port with a DB9 female-terminated RS-232 null modem cable. rx5670 server On the rx5670 server, connect the 4-pair CAT-5 cable to the RJ45 port shown in the following image. Setting up and connecting to the target machine 23