HP J7934G HP Jetdirect 620n Print Server Setup Guide - Page 11
Remove Power to Printer, Install the Hardware - network card
UPC - 882780135604
View all HP J7934G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Remove Power to Printer, Install the Hardware Figure 2-1 Remove Power, Install and Connect the Card RJ-45 1. Turn off the printer and remove the printer's power cord. 2. Identify an available HP Enhanced I/O (EIO) slot (typically, in the back of the printer). Note For printers with multiple EIO slots, you can install the print server into any EIO slot in the HP printer. 3. If the slot has a cover plate, remove it. 4. Insert the print server card. Align the card with the guide rails in the slot. 5. Press the card into the slot until firmly seated and tighten each retaining screw a little at a time until both screws are secure. 6. Connect the network cable to the card using the RJ-45 connector port. 7. Turn on the printer. ENWW Installation Procedures 11