HP Jetdirect 2700w HP Jetdirect 2700w USB Solution Print Server - Administrato - Page 3

HopLimit/WSD Panic Behavior hw-acclrn-conf Set the WS-Discovery hop limit for the site local IPv6 multicast packet. Set the printer behavior when a panic situation is encountered. DUMP_AND_REBOOT JUST_REBOOT DUMP_AND_HALT JUST_HALT FULL_DUMP_AND_REBOOT FULL_DUMP_AND_HALT Use hardware acceleration. 0: Disable. 1 (default): Enable. HP Embedded Web Server The following discusses the changes to the Networking and Web Services tabs of the HP Embedded Web Server. Networking tab TCP/IP Settings The Advanced tab now contains the CCC Logging item. By default, HP Customer Care Center logging (CCC Logging) is enabled. To disable logging, clear the check box. Authorization By default, the HP Jetdirect print server contains a self-signed preinstalled certificate. When using this selfsigned certificate, the Encryption Key Length item now allows you to select an encryption key length of 2048 bits. 802.1X Authentication Both the PEAP and EAP-TLS protocols use dynamic encryption keys for secure communication. If an authentication failure occurs, you can set the new On Authentication Failure item to connect anyway, or block access. Device Announcement Agent Use the Announcement Agent menu item to enable or disable the HP Device Announcement Agent, to set the configuration server, and to indicate whether to require mutual authentication using certificates. When enabled, the HP Device Announcement Agent sends an announcement to a configuration server when the device first connects to your network. The configuration server, such as the HP Imaging and Printing Security Center, then pushes the pre-established configuration settings to the device. 3