HP Kayak XW U3-W3 HP Kayak XW (Series U3-W3), HP Visualize Fx4 Texture Module - Page 12

riotx.bk : riotx-us.fb4 Page 8 Tuesday, December 16, 1997 3:08 PM 1 HP VISUALIZE fx4 Texture Module User's Guide Installing the Texture Module Adding the Texture Module to the VISUALIZE fx4 Board 1 Remove the four screws from the blank stiffener board, then remove the board. (You can use a TorxTM screwdriver or a flat-blade screwdriver of the correct size.) Keep the smallest screw (shown below) to secure the texture module. Reuse this small screw when installing the texture module Blank Stiffener Board Ensure that the stand-off (where the screw goes in) remains fixed to the heat sink Terminator 2 Using both hands, carefully remove the terminator from the VISUALIZE fx4 board. Store the terminator in a safe place (you may need it at a later date). 3 Before installing the texture module, ensure that all four screws on the texture module are fully retracted or removed. 8 English English