HP LH3000r HP NetRAID-4M Installation Guide - Page 115
Flashing the Firmware on a Single Controller
View all HP LH3000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
Flashing the Firmware a Flashing the Firmware on a Single Controller To flash the firmware on a single controller, type the following at the DOS prompt, replacing CONTROLLER_NUMBER with the number of the controller whose firmware you are flashing. \> afu update /c CONTROLLER_NUMBER To upgrade controller 0, for example, you would type the following: \> afu update /c 0 b Flashing the Firmware on Multiple Controllers To flash the firmware on multiple controllers, type the following at the DOS prompt, replacing the commaseparated list of CONTROLLER_NUMBER_? with the numbers of the controllers whose firmware you are updating: \> afu update /c CONTROLLER_NUMBER_1,CONTROLLER_NUMBER_2 To upgrade controllers 0, 2, and 3 for example, you would type the following: \> afu update /c 0, 2, 3 c Flashing the Firmware on All Controllers To flash the firmware on all controllers, type the following at the DOS prompt: \> afu update /c all 6 The firmware image is contained on two diskettes. The AFU prompts you to put in the first firmware diskette. When it detects that the diskette is in the drive, the AFU will read the part of the firmware image contained on the first diskette. 7 The AFU then tells you to remove the first firmware diskette and insert the second firmware diskette. The AFU will read the second part of the flash image, and then perform a checksum operation to verify that all the data was read correctly. D-3