HP LH4r hp lp 1000r and ds2100 config guide — for Microsoft Windo - Page 3
Enclosure, Cables, Power distribution, Server, Network
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
LP1KR2K2M21 Shared Storage Configuration Parameter Configuration options Enclosure Disk drives Number of cabinets Model Disk SCSI IDs SCSI ID Switch Settings Cables SCSI Specification Termination disabled by physical jumper setting -- Cover J3 pins 2-3. See jumper diagram on page 5. Cluster mode on Cache write policy to Write thru Any HP drive supported by storage enclosure. Any combination of HP disk models is allowed in an array, on a SCSI channel, or in a cluster. One or two per cluster HP Surestore DS2100 A5676A SCSI ID switch B or C When daisy-chaining two DS2100 enclosures, each must have a different switch setting. Set one DS2100 to switch B, and the other to switch C. In single DS2100 clusters, set the switch to either B or C. B - 8,10,12,14 C - 9,11,13,15 C7541A (Quantity = two, required) - 2 Meter in-line terminated cable (to connect NetRAID-2M to DS2100) C2978B (Quantity = one needed only when configuring two DS2100s in the cluster) - 0.5 meter LVD cable Power distribution Layout See SCSI cabling diagrams starting on page 6. Redundant power distribution units (PDUs) are recommended. See power cabling diagram on page 8. Microsoft® and HP Certified Server Configuration Parameter Server I/O card slot Network interfaces Boot device Specification PCI slot 1, NetRAID-2M shared storage controller Embedded NICs for both intra-cluster (heartbeat) and client LANs Embedded SCSI Intra-Cluster (Heartbeat) LAN Configuration Parameter Network Connection NIC Quantity Specification HP D5954A crossover cable, or equivalent. The intra-cluster LAN may only be used for cluster node communication. It may not be used for client communication. One 11/15/01 3