HP LH4r hp lp 1000r netraid-2m config guide — for Microsoft Windo - Page 2

LP1000R2K2M Server Configuration Parameter I/O slot Default boot order Local Storage Controller Driver Physical drive location Disk drives SCSI bus SCSI IDs System software Navigator CD-ROM Operating system Service pack Power distribution Layout Specification PCI slot 1 IDE CD-ROM, FDD, embedded SCSI, PCI slot 1 Embedded SCSI Sym_u3.sys, version 5.07.00, or later (driver obtained from Navigator CD-ROM L.20.00, or later) Server internal drive bays, or HP external drive cabinet (e.g., HP Rack Storage/12) Must be HP Any HP cables that meet SCSI specifications, and any SCSI bus speed Any Version M.04.00, or later Microsoft Windows® 2000 Advanced Server Latest service pack version Redundant power distribution units (PDUs) are recommended. See power cabling diagram on page 6. Shared Storage Configuration Parameter Controller Model Number of controllers BIOS Firmware Driver NetRAID Assistant SCSI ID Channels RAID levels Logical disks Configuration options Enclosure Disk drives Number of cabinets Specification HP NetRAID-2M Controller, Model P3411A, or P3475A One Disabled Version H.01.08 (firmware obtained from Navigator CD-ROM, version M.04.00, or later) Mraid2k.sys, version 5.20 (driver obtained from Navigator CD-ROM, version L.20.00, or later) Version B.01.04, or later (software obtained from Navigator CD-ROM, version L.20.00, or later) 6, 7 0, 1 1, 5, 10, 50 One per RAID array Eight, maximum, per cluster Cluster mode on Cache write policy to Write thru Any HP drive supported by storage enclosure. Any combination of HP disk models is allowed in an array, on a SCSI channel, or in a cluster. One or two per NetRAID-2M controller 11/7/01 2