HP LH4r hp lp 2000r and ds2100 config guide — for Microsoft Windo - Page 6

LP2KR2K2M21 NOTES: 1. To connect server to DS2100 -- C7541A - 2 Meter ILT cable 2. This diagram shows using a single DS2100. You can use from one to two storage cabinets per cluster. See the next cabling diagram for a configuration using two DS2100s. connect to NetRAID-2M channel 0 only! 3. Only connect channel 0 of the NetRAID-2M to the DS2100. Using channel 1 is not supported. 4. There are no 'left'or 'right'port requirements for cabling to the DS2100. Cables can be attached to either port. 5. Connect LAN ports A for the heartbeat cluster interconnect. Use ports B for the client LAN connection. 6. Here, the DS2100 SCSI ID switch is set to B. The following addresses will be assigned to installed disks: 8, 10, 12, and 14. Setting B or C is supported. × LAN A LAN B Heartbeat - Client LAN Connection -crossover cable or equivalent SCSI Switch A B C × LAN A LAN B Heartbeat - Client LAN Connection -crossover cable or equivalent HP Netserver LP 2000r Cluster using one HP Surestore DS2100 Disk System 11/15/01 6