HP LH4r hp netserver lc 2000 netraid-4m config guide — for Micros - Page 2

lc20002k4m Server Configuration Parameter Number of power supplies I/O slots Default boot order Local Storage Controller Driver Physical drive location Disk drives SCSI bus SCSI IDs System software Navigator CD-ROM Operating system Service pack Power distribution Layout Specification One standard, two required for redundancy Added cards may be installed in any appropriate slot, considering the server default boot order provided below. IDE CD-ROM, FDD, embedded SCSI A, embedded SCSI B, PCI slot 1, PCI slot 2, PCI slot 3, PCI slot 4, PCI slot 5, PCI slot 6 Embedded SCSI, NetRAID-1Si, NetRAID-3Si, NetRAID-1M, or NetRAID-2M For embedded SCSI, sym_hi.sys, version 4.12.00, or later For NetRAID-1Si/3Si, mraid35x.sys, version 2.66, or later For NetRAID-1M/2M, mraid2k.sys, version 5.20, or later (all drivers obtained from Navigator CD-ROM, version L.20.00, or later) Server internal drive bays, or HP external drive cabinet (e.g., HP Rack Storage/12) Must be HP Any HP cables that meet SCSI specifications, and any SCSI bus speed Any Version L.20.00, or later Microsoft Windows® 2000 Advanced Server Latest service pack Redundant power distribution units (PDUs) are recommended. See power cabling diagram on page 5. Shared Storage Configuration Parameter Controller Model Number of controllers BIOS Firmware Driver NetRAID-4M FAST SCSI ID Channels RAID levels Specification HP NetRAID-4M Controller, Model D9161A, or D9351A One or two Disabled Build version 4584 (firmware obtained from Navigator CD-ROM, version L.20.00, or later) Hpn.sys, version 2.4.0.4581, displayed in FAST as version 4581 (driver obtained from Navigator CD-ROM, version L.20.00, or later) Version 2.4-0, or later (software obtained from Navigator CD-ROM, version L.20.00, or later) 6, 7 0, 1, 2, 3 All fault-tolerant RAID types supported by controller: 1, 5, 10 (stripe set of mirror sets RAID 0/1), 50 (stripe set of RAID-5 sets), volume set of mirror sets, volume set of RAID-5 sets 1/28/02 2