HP LH4r HP Netserver LH 3 Installation Roadmap - Page 4

7 Install Additional Memory NOTE Use only HP DIMMs listed in HP Information Assistant or in HP Order Assistant. System Board DIMM Socket 0 DIMM Socket 1 DIMM Socket 2 DIMM Socket 3 1. Remove cover 3 as described in panel 6, "Removing and Replacing the Covers." 2. Install the DIMMs (refer to figure at right): Choose a socket into which you want to install a DIMM. DIMMs may be installed in any combination, in any socket. Spread the two retaining clips on the socket outward. Align the notches on the DIMM with the keys on the socket. Holding the DIMM at 90 degrees to the system board, press the DIMM fully into the socket until the retaining clips close. If the clips do not close, the DIMM is not inserted correctly. DIMM Notches Keys Retaining Clips 3. Replace the cover(s): If you are not installing any other accessories, install the cover(s) as described in panel 6, "Removing and Replacing the Covers." 8 Install All Accessory Boards NOTE For a list of boards HP has tested, see Help topic "Tested Parts List" on the HP Navigator CD-ROM. 1. Remove cover 1 as described in panel 6: "Removing and Replacing the Covers." 2. Read the documentation included with each accessory board. Follow any special instructions and installation recommendations. Some boards have preferred slot locations. If not, consider the boot order (see below) when choosing the accessory board socket in which to install the board. Accessory Board Guide Release Tab Accessory Board Retainer 3. Remove the slot cover for each slot to be used, and store it for future use. If you are installing any full-length PCI boards, also remove the accessory board retainer. Push on the button on the retainer to release it, and then slide it out of the board guide. 4. Install the boards: Insert each board in the desired slot and fasten the board's mounting screw at the slot opening at the rear of the chassis. Connect any required cables to the boards. If you removed the board retainer, reinstall it. Slot 1 16-bit ISA or 32-bit PCI Slot 2 32-bit PCI Slot 3 32-bit PCI Slot 4 32-bit PCI Slot 5 32-bit PCI Slot 6 32-bit PCI Slot 7 32-bit PCI Slot 8 32-bit PCI NOTE If you install an ISA non-Plug-and-Play board, you must reserve system resources (some or all of: memory addresses, I/O addresses, IRQs, and DMA channels) for it. Write down that information now for reference when you reserve system resouces in Section 12: "Configure the HP NetServer." Boot Device Priority Boot order for PCI controllers is determined by slot location. The system searches for a bootable device in the following order: 1. IDE CD-ROM drive with a bootable CD-ROM. 2. Flexible disk drive with a bootable flexible disk. 3. Embedded SCSI controller or embedded DAC. 4. PCI boards in slots in the following order: 8, 7, 6, 5, 4, 3, 2, 1. This boot order can be changed using the SETUP utility (press [F2] during the boot process). An accessory board can be identified by the offset of the bracket and the shape of the edge connector: PCI Board- Left-Side Offset ISA Board- Right-Side Offset