HP LH4r HP Netserver LH 3r Installation Roadmap - Page 2

NetServer LH 3r Installation Road Map Table of Contents 1. Verify Contents 2. Obtain Novell IntranetWare Key (Optional) 3. Overview of NetServer Features 4. Obtain HP Navigator CD-ROM Release History 5. Removing and Replacing the Covers 6. Install Additional Memory 7. Install All Accessory Boards 8. Replace Covers and Cables 9. Install the NetServer in the Rack 10. Install Additional Mass Storage Devices 11. Make External Connections 12. Configure the HP NetServer Audience Assumptions This road map is intended for the person who installs, administers, and troubleshoots LAN servers. Hewlett-Packard Company assumes that you are qualified in the servicing of computer equipment and trained in recognizing hazards in products with hazardous energy levels. ESD Warning This HP NetServer contains sensitive electronic devices that can be damaged by electrostatic discharge (ESD). ESD hazards are a result of installation or service personnel failing to ground themselves properly. To be properly grounded, use a proper ESD wrist strap and work surface grounded to the HP NetServer chassis. Tools Required Installation of some accessories require a T15 TORX® or a 1/4-inch flat blade screwdriver, depending on the accessory. 1 Verify Contents Unpack and verify the contents of the shipping box against the Contents Checklist included with your HP NetServer. If anything is missing or damaged, contact your reseller. 2 Obtain Novell IntranetWare Key Obtain IntranetWare software key (optional): If you plan to install the optional Novell IntranetWare software that came with your HP NetServer, purchase the software and obtain the key before beginning NOS installation in panel 12, "Configure the HP NetServer." Use the key request form in the HP NetServer Software Option Package. 3 Overview of NetServer Features Shelf 1 (Flexible Disk Drive) Shelf 2 (CD-ROM Drive) Shelf 3 (Empty) Hot-Swap Mass Shelf 4 (Empty) Storage Expansion Bay (Empty) Accessory Board Slot Covers Hot-Swap Power Supply Expansion Bay (Empty) Hot-Swap Mass Storage Cage Front View Power Switch Reset Switch Keyboard Lock Switch Status Lights Display Control Buttons Front Panel Display I/O Connectors: Remote Management Serial B Serial A Parallel Mouse Keyboard Monitor Accessory Board Sockets NOTE Power redundancy requires three power supply modules. No redundancy is available with two modules. I/O Board AC Power Connector Hot-Swap Power Supply Modules Rear View Hot-Swap Power Supply Cage Backplane Redundant Fan Expansion Bay (Empty) Top View System Board Bottom View