HP LH4r HP Netserver LH 3r Third Party Rack Installation Guide - Page 14
Mounting the Slides
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Chapter 3 Installation Mounting the Slides 1. Orient each slide so that the front of the slide attaches to the front column and the rear attaches to the rear column. This ensures that once installed, the slides will extend correctly, toward the front of the rack (see Figure 3-3). NOTE The slides do not come apart; they are one piece. Rear Flange Front Flange Extendible Members Figure 3-3. Slide Components and Orientation 2. Place the mounting flange of the slide between the inside of the column and the bar nut (see Figure 3-4). Do this at the front and rear of the slide. 3. Press the slide firmly against the columns, lift up against the screws, and tighten all four screws. NOTE It is very important to lift up on the slides prior to tightening the screws. Tightening the screws without lifting up on the slides will result in interference between the NetServer and other equipment in the rack; you may not be able to slide the NetServer into the rack enclosure after completing the installation. 4. Repeat for the other slide. 10