HP LH4r HP Netserver LH 3r Third Party Rack Installation Guide - Page 15

Installing the NetServer

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Chapter 3 Installation Push In and Up Figure 3-4. Mounting a Slide to a Column Installing the NetServer 1. Extend the slides until you hear a click, indicating they are fully extended in the locked-out position. Note that the slides do not come apart (see Figure 3-3). WARNING To prevent the rack from tipping over, be sure that the stabilizing, anti-tip feature is installed on this rack enclosure (see Figure 1-2). 2. Before you lift the NetServer, remove the power supply modules and the hot-swap hard disk drives to reduce the weight. WARNING This NetServer weighs up to 160 pounds (73 kg.) when fully configured. Remove all power supply modules and hot-swap hard disk drives before lifting the NetServer. Use two people when moving the NetServer or lifting it into the rack. 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
Chapter 3
Installation
11
Push In and Up
Figure 3-4.
Mounting a Slide to a Column
Installing the NetServer
1.
Extend the slides until you hear a click, indicating they are fully extended
in the locked-out position. Note that the slides do not come apart (see
Figure 3-3).
WARNING
To prevent the rack from tipping over, be sure that the
stabilizing, anti-tip feature is installed on this rack enclosure
(see Figure 1-2).
2.
Before you lift the NetServer, remove the power supply modules and the
hot-swap hard disk drives to reduce the weight.
WARNING
This NetServer weighs up to 160 pounds (73 kg.) when fully
configured. Remove all power supply modules and hot-swap
hard disk drives before lifting the NetServer.
Use two people when moving the NetServer or lifting it into
the rack.