HP LH4r HP Netserver LH 3r Third Party Rack Installation Guide - Page 9
Overview
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
2 Overview The steps required to install the NetServer in the rack are summarized below: NOTE This is only a summary; detailed instructions are provided on the following pages. • Measure and mark the appropriate holes on all four rack columns • Install one bar nut on each of the four rack columns • Insert two rack nuts on each of the two front columns only • Attach the slides to the columns • Extend the slides • Remove power supply modules and hot-swap drives from the NetServer • Lift the NetServer onto the slides • Secure the NetServer to the slides • Remove the lifting handles from the NetServer • Install the power supply modules and hot-swap drives in the NetServer • Push the NetServer back into the chassis • Install the recessed mounting brackets on the two front columns only 5