HP LH4r HP Netserver LH Pro NetRAID Installation Guide - Page 20

Part 2: Setting Up the HP Storage System/6 Assigning SCSI IDs To configure the shared disks, you need to change the SCSI ID assignments for each of the HP Storage System/6 units you are including in the cluster: 1. Check, and if necessary re-assign, SCSI ID's for both the upper and lower cages. Configure the DIP switches as indicated in the figure below. Note that the upper cage settings are shown in their default positions. Off On 1 2 3 4 UPPER CAGE 5 6 1 2 3 LOWER 4 CAGE 5 6 HP Storage System/6 DIP Switch and Cluster Assignments 2. Reattach and close the HP Storage System/6 door. Replace the front bezel. Leave the power off. The HP Storage System/6 must be operated with the door closed to ensure proper airflow and to prevent radio frequency interference. Repeat Steps 1-2 for each HP Storage System/6 to be included in the cluster. When you have finished, the hardware configuration of the Storage System/6 is complete. You are now ready to proceed to "Part 3: Configuring the HP NetRAID Adapter." WARNING Do not cable the shared storage units to System A and B at this time. You must configure the HP NetRAID Adapter (Part 3), and install Microsoft Windows NT Server, Enterprise Edition (Part 4) before attaching the HP Storage System/6. HP NetServer LH Pro Microsoft Cluster Installation Guide - 1 October 1997 11