HP LH4r HP Netserver LXr 8000 Memory Upgrade Guide - Page 29

Removing DIMMs From the Memory Board

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 29 highlights

CAUTION Do not rock the DIMM into place, but apply firm and even pressure. If a gap exists between the retaining clips and the DIMM module, remove the module and repeat steps 5-6. 7. Repeat steps 3 through 6 to install the other three DIMMs, according to the rules listed in "Memory Configuration Guidelines," until you have installed all DIMMs for your memory configuration. Removing DIMMs From the Memory Board CAUTION Wear a grounded anti-static wrist strap connected to the NetServer chassis before installing DIMMs. Follow these guidelines for removing DIMMs. • If reducing the number of DIMMs on the board, remove them only in increments of one full bank (four DIMMs). • When you finish removing DIMMs, the remaining DIMMs should be arranged on the board in one of the configurations shown in Figures 2-4 through 2-7. 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
23
CAUTION
Do not rock the DIMM into place, but apply firm and
even pressure.
If a gap exists between the retaining
clips and the DIMM module, remove the module and
repeat steps 5-6.
7.
Repeat steps 3 through 6 to install the other three DIMMs,
according to the rules listed in “Memory Configuration
Guidelines," until you have installed all DIMMs for your memory
configuration.
Removing DIMMs From the Memory Board
CAUTION
Wear a grounded anti-static wrist strap connected to
the NetServer chassis before installing DIMMs.
Follow these guidelines for removing DIMMs.
•
If reducing the number of DIMMs on the board, remove them only
in increments of one full bank (four DIMMs).
•
When you finish removing DIMMs, the remaining DIMMs should
be arranged on the board in one of the configurations shown in
Figures 2-4 through 2-7.