HP LH4r HP Netserver LXr 8000 Memory Upgrade Guide - Page 30
Remove the memory board. See Removing the Memory Board.
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
• When removing banks of DIMMs from a system with two memory boards, make sure that both boards have identical DIMM configurations when you finish. (But if you are reducing the system to its minimum memory configuration, four DIMMs, put all four DIMMs on the primary (right) board and leave the other board empty.) See "Memory Configuration Guidelines" for DIMM placement guidelines. Follow these steps to remove a bank of four DIMMs: 1. Power down the HP NetServer. See Chapter 2 of the HP NetServer LXr 8000 Installation Guide for details. 2. Remove the HP NetServer's front bezel. See Chapter 3 of the HP NetServer LXr 8000 Installation Guide for details. 3. Remove the memory board. See "Removing the Memory Board." 4. Determine which bank of DIMMs you wish to remove. 5. Open the retaining clips of the first DIMM just enough so that you can lift the DIMM's top edge away from the clips. 6. Lift the DIMM completely away from the socket. 7. Place the DIMM in its anti-static container. 8. Repeat steps 5 through 7 for the other three DIMMs in the bank. 24