HP LaserJet MFP M72625-M72630 Engine Install Guide - Page 1
HP LaserJet MFP M72625-M72630 Manual
View all HP LaserJet MFP M72625-M72630 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
HP LaserJet MFP M72625, M72630 ( ( Engine Install Guide NJ OE support.hp.com www.hp.com/videos/A3install HP recommends reviewing the video before performing the installation. WARNING: Make sure the work area is free of debris and the floor is not slippery or wet. CAUTION: The printer assembly is heavy. Four people must lift and install it on the dual cassette feeder (DCF) (Y1F97A), the 2000-sheet high capacity input (HCI) (Y1F99A), or the stand (Y1G17A). 1 Unpack and acclimate the printer. CAUTION: Before the printer is powered on, make sure that the room and equipment are at least 15°C (59°F). NOTE: Leave the printer on the shipping pallet until it is ready to install on a DCF, HCI, or stand. 1.1 Remove the printer, imaging drum, toner collection unit (TCU), and associated hardware from the box. After unpacking the printer and supplies, allow them to acclimate for four hours. NOTE: If the printer and hardware were stored below 0°C (32°F), it may take them longer to acclimate. CAUTION: Do not remove the shipping tape or protective packing materials until after the printer is installed on a DCF, HCI, or stand. (Step 3.2) NOTE: The imaging drum is stored in the output bin area below the automatic document feeder. 1 1.2 Pull the protective clear plastic down to the base of the printer to allow access to lifting points.