HP Latex 110 Site preparation guide - Page 5

Overview, Introduction, Documentation, Customer responsibility

Get HP Latex 110 PDF manuals and user guides View all HP Latex 110 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 5 highlights

1 Overview Introduction Your printer is supplied ready to use after a few simple installation procedures described in detail in the Assembly instructions. It is important to read the information provided in this guide thoroughly and to ensure complete compliance with all installation and operation requirements, safety procedures, warnings, cautions and local regulations. A well prepared site helps to provide a smooth and easy installation. Documentation The following manuals are provided with your printer, and can also be downloaded from http://www.hp.com/go/Latex300/manuals/. ● Introductory information ● Limited warranty ● Legal information ● Site preparation guide (this guide) ● Assembly instructions ● User's guide Customer responsibility You are responsible for preparing the physical site for the installation of the printer. ● Prepare the building's electrical system to meet the printer's requirements and the Electrical Code requirements according to the local jurisdiction of the country where the equipment is installed. See Electrical configuration on page 6. NOTE: Make sure that a certified electrician reviews the setup and configuration of the electrical system used to power the printer. See Electrical configuration on page 6. ● Meet temperature and humidity requirements and ensure proper ventilation for the printer. See Environmental specifications on page 4. ● Meet all requirements for RIP, networking and printing supplies. See RIP workstation characteristics on page 5, Networking on page 5 and Printing supplies on page 6. ● Prepare the unloading route so the printer can be unloaded and maneuvered into place. See Unloading route on page 3. ENWW Introduction 1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
1
Overview
Introduction
Your printer is supplied ready to use after a few simple installation procedures described in detail in the
Assembly instructions
. It is important to read the information provided in this guide thoroughly and to ensure
complete compliance with all installation and operation requirements, safety procedures, warnings, cautions
and local regulations. A well prepared site helps to provide a smooth and easy installation.
Documentation
The following manuals are provided with your printer, and can also be downloaded from
go/Latex300/manuals/
.
●
Introductory information
●
Limited warranty
●
Legal information
●
Site preparation guide (this guide)
●
Assembly instructions
●
User's guide
Customer responsibility
You are responsible for preparing the physical site for the installation of the printer.
●
Prepare the building's electrical system to meet the printer's requirements and the Electrical Code
requirements according to the local jurisdiction of the country where the equipment is installed. See
Electrical configuration
on page
6
.
NOTE:
Make sure that a certified electrician reviews the setup and configuration of the electrical
system used to power the printer. See
Electrical configuration
on page
6
.
●
Meet temperature and humidity requirements and ensure proper ventilation for the printer. See
Environmental specifications
on page
4
.
●
Meet all requirements for RIP, networking and printing supplies. See
RIP workstation characteristics
on page
5
,
Networking
on page
5
and
Printing supplies
on page
6
.
●
Prepare the unloading route so the printer can be unloaded and maneuvered into place. See
Unloading
route
on page
3
.
ENWW
Introduction
1