HP M4345x HP LaserJet M4345 MFP - Software Technical Reference (external) - Page 206
Output Protocol, Send Ctrl-D Before Each Job, Convert Gray Text to PostScript Gray, ASCII, Binary
UPC - 882780548947
View all HP M4345x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 206 highlights
best to set the postscript memory to match the total RAM that appears on the configuration page. To print a configuration page from the device control panel, follow these steps: 1. Touch Administration. 2. Touch Information. 3. Touch Configuration/Status Pages. 4. Touch Configuration Page. 5. Touch Print. Output Protocol This control specifies the protocol that the device uses for print jobs. The following options are available: ● ASCII (default) ● TBCP ● Binary Click ASCII to send data in ASCII format (7-bit), which might take longer to print but can be sent through any I/O channel, such as a serial or network port. Click TBCP (Tagged Binary Communications Protocol) to send all data except special control characters in binary (8-bit) format. The binary formats can be sent over serial communications ports and are faster than sending data in ASCII format. Click Binary to send all data except special control characters in binary (8-bit) format. The binary formats can be sent over serial communications ports and are faster than sending data in ASCII format. Send Ctrl-D Before Each Job This control specifies whether the device is reset at the beginning of every postscript document. The default setting is No. Pressing Ctrl-D resets the device to its default setting to ensure that previous print jobs do not affect the current print job. Using Ctrl-D might cause a print job to fail if the device is connected through a network. If the document fails to print when sent to a device connected through serial ports, change No to Yes. Send Ctrl-D After Each Job This control specifies whether the device is reset at the end of every postscript document. The default setting is Yes. Pressing Ctrl-D resets the device to its default setting to ensure that future print jobs are not affected by the current print job. Using Ctrl-D might cause a print job to fail if the device is connected through a network. If the document fails to print when sent to a network device, change Yes to No. Convert Gray Text to PostScript Gray This control specifies whether to convert the true gray value (RGB) in text to the gray that the driver provides. The following settings are available: ● Yes ● No (This is the default setting.) HP drivers for Windows 186 Chapter 5 HP PCL 6, PCL 5, and PS Emulation drivers for MS Windows ENWW