HP Mellanox SX1018 Mellanox MLNX-OS Release Notes for SX1018HP Ethernet Manage - Page 8
Index, Category, Description, Possible Workaround
View all HP Mellanox SX1018 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Index Category 4. LAG 5. LAG 6. LAG 7. LAG 8. VLAN 9. Spanning Tree 10. IGMP Snooping 11. ACL 12. ACL 13. ACL Description Possible Workaround The remote LACP admin-key #1 cannot be estab- Use a different admin-key lished with some third party vendors. number. Traffic running over LAG may not be evenly distributed when testing small number of SMACs. A port-channel stops forwarding traffic after disabling some Ethernet ports in the same port-channel group. Disable and enable the LAG. When converting static LAG to dynamic LAG (LACP), some of the ports remain in 'DOWN' state. Disable and enable the LAG. It might take approximately 20 seconds to create/ delete 1000 VLANs, or to change the switchport mode of an interface. Non-standard behavior may occur on third party switch STP functionality when the port moves from Root to Alternate state. The standard Proposal-Agreement sent by MLNX-OS is unanswered which may result in traffic loss of up to 30 seconds. Setting the "ip igmp snooping unregistered multicast" option to "forward-to-mrouter-ports" option reduces the amount of supported VLANs to 250. A mask of IPv4 ACL rule can contain either 255 or 0 in any of the 4 bytes assembling it. ACL is not supported on split interfaces. Removing configured ACL on split interfaces requires reset factory. Mellanox Technologies 8