HP Mini 210-2100 HP Mini 210 - Maintenance and Service Guide - Page 75
Remove the system board, Reverse the procedure to install the system board.
View all HP Mini 210-2100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Remove the system board: 1. Disconnect the power connector cable from the system board. 2. Remove the 2 Phillips 2.0×4.0 screws (1) that secure the system board to the base enclosure. 3. Lift the right side of the system board (2) until it rests at an angle. 4. Remove the system board (3) by sliding it up and away from the base enclosure. Reverse the procedure to install the system board. Component replacement procedures 65
Remove the system board:
1.
Disconnect the power connector cable from the system board.
2.
Remove the 2 Phillips 2.0×4.0 screws
(1)
that secure the system board to the base enclosure.
3.
Lift the right side of the system board
(2)
until it rests at an angle.
4.
Remove the system board
(3)
by sliding it up and away from the base enclosure.
Reverse the procedure to install the system board.
Component replacement procedures
65