HP Model 715/100XC hp 9000 series 700 model 715 workstations service handbook - Page 125
Memory
View all HP Model 715/100XC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Memory Before removing the memory, perform the following steps: S Remove the optional graphics processor (if installed). S Remove the floor stand. S Open the system unit. Remove the memory board by pushing open the spring clips, as shown in Figure 5-40. Tilt the top edge of the board about 45° toward the front of the system unit and pull evenly on both ends of the board to release it from the connector. Figure 5-40. Removing Memory Boards 5-40 Field Replaceable Units
5–40
Field Replaceable Units
Memory
Before removing the memory, perform the following steps:
S
Remove the optional graphics processor (if installed).
S
Remove the floor stand.
S
Open the system unit.
Remove the memory board by pushing open the spring clips, as shown in
Figure 5–40. Tilt the top edge of the board about 45
°
toward the front of the system
unit and pull evenly on both ends of the board to release it from the connector.
Figure 5–40.
Removing Memory Boards